Gauge Wheel Arm Repair Kit Case IH 800/900 ConcaveSummer as there is no need

as there is no need to balance the gauge wheel on a knee while trying to thread a new bolt into the tapped hole

This kit replaces the bushing on a closing wheel arm with a bearing

FLOATING ROW CLEANER MLOUNT FOR 6X6 OR 7X7 TOOL BAR

bushing and washers to mount closing wheels with standard 40mm bearings

1013718VL-H

Gauge Wheel Arm Repair Kit Case IH 800/900 ConcaveSummer as there is no needPR1333: GWA Repair Kit Case IH 800 900 per row The gauge wheel arm pivot is the #1 wear point on planters. This is caused by the fact that the ground load on the gauge wheel is offset from the center of the row where the arm contacts the adjustable stop. This offset load is supported by two points of contact between the pivot pin and the bore of the hub. These points wear and the arm starts to lean allowing the tire to pull away from the opener disk.